Install Kitchen Cabinets Yourself and Save Thousands

It would be great that by doing it yourself, you could put that extra money to work for you, such as new appliances, upgraded countertops, flooring or possibly even custom cabinets. If you install kitchen cabinets yourself, you can do just that!



But, as with any home improvement project, there are some things that you will need to know if you plan on doing it yourself. I will be glad to help you along the way if you have been searching for the answer to installing kitchen cabinets on your own in that new kitchen of yours.

Now, to begin with, you are going to need some basic hand tools and power equipment to get the job done right. The tools that I am referring to is the hammer, drill, whether power or battery operated, jig saw, nail set, countersink drill bits, belt sander, table saw or even a circular saw, a two foot and four foot level and a tape measure.

So, the next step in the installation of your new kitchen is to go over the layout of the new design, and to determine the highest point of your existing kitchen floor. So, once that task has been completed, you will want to start with the corner wall cabinet.

You will want to use your stud finder to determine where the studs are located behind the wall. Take those measurements of the stud locations and transfer them onto the back of the corner wall cabinet, or preferably on the inside of the cabinets.

This is where you will want to double check that the marks for the drill holes are loacted close to the top and bottom of the cabinet which is the strongest point. This is very important that you make sure to take your time and install the kitchen cabinets level and plumb in order to keep the run of cabinets straight and true.

I cannot emphasize this last step enough, because if you get this wrong, you are going to be hating life a little later down the road. Trust me, you will have a much easier time with your kitchen cabinet installation if you take the time to do so.

You will find that your walls are not going to be perfect, and you will have to shim the wall cabinet in several areas. Again, you will find that by getting this step right, the rest of the cabintery will just be placed against the previous cabinet and screwed into place.

Now, this by no means that you will not have to plumb and level the next cabinets, but you will not be faced with the problem of trying to overcome the incorrect installation of the first cabinet. Now, in order to make the cabinets ligher and to protect the doors, I recommend that you remove them from the cabinets.

You want to make sure that you try to keep any damage to the doors to a minimum, because as you would find out if you needed to have one replaced, they are the most expensive part of the cabinet.

There are so many different aspects to any kitchen remodeling project that just knowing the basics as to how to install kitchen cabinets is not going to be enough to go on if you are trying to do the job yourself.

However, if you have the information and the advice from someone that has experience in kitchen remodeling, you should be able to install your kitchen without any problems, so I have put together a guide for you at http://installkitchencabinetshelp.com/.